A plasma cutter uses a stream of compressed gas (air, nitrogen, argon, etc.) and a consumable wire electrode as the two primary feedstocks of the steel cutting process. The electrode sends a high electrical charge through the gas, raising its temperature to the point of ionization to generate extremely hot plasma (~20,000°C). This plasma is directed through the cutting tip to create a highly focussed beam, with velocities approaching the speed of sound.
The qualified flat steel has sufficiently high high temperature strength and high temperature plasticity. Therefore, S235J0, S235J2, S275JR hot rolled sheet flat steel is not only required to have high enough normal temperature and instantaneous high temperature tensile strength and plasticity, but also long-term strength and long-term plasticity to ensure long-term safe work at high temperatures, especially under creep leakage conditions. The product thickness is 8-50mm, width 150-625mm, length 5-15m。
ASTM A633 material is particularly suited for service at low ambient temperatures and higher where notch toughness better than that expected in as-rolled material of a comparable strength level is desired. S235J0, S235J2, S275JR hot rolled sheet, A633 Grade E high-strength low-alloy structural steel provides a minimum yield point of 60 ksi [415 MPa] in thicknesses up to 4.0 in. [100 mm], inclusive and 55 ksi [380 MPa] in thicknesses over 4 in. to 6 in. [100 to 150 mm], inclusive.
Using advanced logistics management, advanced models and management experience to increase the reliability of logistics operations and provide customers with 24/7 cargo management. On the premise of reducing transportation and management costs as much as possible, we provide customers with high-quality and efficient services; good business reputation has been recognized and supported by our customers.