Aspire to technological innovation and pursue first-class quality steel sa709gr50w asme low alloy steel products.Take independent innovation as an important support for the sustainable development of iron and steel industry, strengthen the main position of technological innovation, accelerate the original innovation, integrated innovation, introduction, digestion, absorption and re innovation, improve the technological innovation system, and cultivate the core technology and brand products of independent intellectual property rights.
Smelting process of sa709gr50w asme low alloy steel, container plate SPA-H weather-resistant steel: The molten iron for smelting SPA-H steel must be pretreated by molten iron desulfurization. Before entering the converter, the sulfur content of the molten iron is ≤0.010%, and the slag on the surface of the molten iron is cleaned. Nickel plates, copper particles or nickel-copper alloys are added to the converter with scrap steel. The carbon content of the converter smelting end is required to be less than 0.06% to prevent the molten steel from being oxidized.
Boiler steel refers to the special steel used to manufacture pressure components of steam boilers, such as steam drums. The boiler steel mainly means boiler steel plates and seamless boiler steel pipes. Boiler components not only bear pressure loads but are also heated by direct fire, so the requirements on the chemical composition and mechanical properties of boiler steel, sa709gr50w asme low alloy steel are strict. In the chemical composition of boiler steel, sa709gr50w asme low alloy steel, sulfur and phosphorus are strictly controlled. Tensile strength, yield point, elongation, impact energy value and 180 ° cold bending are required to be tested in boiler steel mechanical properties. In addition, strain aging impact test is also required for boiler steel. The quality control of boiler steel is slightly higher than that of pressure vessel steel.
The Seamless Pipe Q345D to Thailand. In November of 2015, Thailand OTTO group contacted with us from Internet. They are finding the trustable supplier of S355/2H seamless pipe for the cable car supporter. Due to the special using of the pipes, they are very careful and serious when choosing the supplier. After one months contact and discussion by email, they come to our company. We drive to the pipe mill for visit of 2 days. Through this visit, they are very confident with our production ability and products quality. Finally, they accept the grade we suggest Q345D. After back to office, they put the order of 1800 tons pipe to us directly.
Leave a Comment