Common SA514 Gr A quenched and tempered plate, steel plate thickness specifications are as follows: Thick steel plate: thickness greater than 4, width within 10 is less than 2000mm, width above 10 is generally 2000, 2500mm, length 4-12m; Thin steel plate: thickness less than 4mm, width 500-1500mm, length 1.5-4m; Flat steel: thickness 4-60mm, width 12-200mm, length 3-9m.
Composition characteristics of low alloy structural steel, SA514 Gr A quenched and tempered plate: (1) Low carbon: the carbon content of low alloy structural steel is less than 0.20% due to the high requirements of toughness, weldability and cold formability. (2) The alloy elements such as manganese are added. (3) The addition of Nb, Ti or V and other auxiliary elements: a small amount of Nb, Ti or V forms fine carbides or carbonitrides in the steel, which is beneficial to obtain fine ferrite grains and improve the strength and toughness of low alloy structural steel. In addition, adding a small amount of copper (≤ 0.4%) and phosphorus (about 0.1%) can improve the corrosion resistance. The addition of a small amount of rare earth elements can remove sulfur and gas, purify the steel, and improve the toughness and process performance of low alloy structural steel.
We can process the steel materials according to your drawing. Or if you can not make drawing, please send us SA514 Gr A quenched and tempered plate specific data and requirements, our technical department can make design and drawing for you, and then confirm with your technician or engineer. If all is OK, our processing center will process the steel materials according to the drawing. So no matter what size and shapes you need, we can meet demands at the most time.
The effect of alloy elements on the properties of heat treatment methods for thick steel plate: the performance of heat treatment method reflects the difficulty coefficient level of heat treatment process and the tendency of defects caused by heat treatment process. The key points include cutting performance, over temperature sensitivity, quenching aging tendency and air oxidation carburizing tendency. SA514 Gr A quenched and tempered plate, Carbon steel has high machinability, and slow cooling method can be used in heat treatment, which can reduce the deformation and cracking tendency of the products. The addition of Mn and Si will increase the over temperature sensitivity of steel.
Leave a Comment